skip to Main Content

Welcome

Say hello to the toggle bar. This is an optional section you can use to display any content you'd like. Simply select a page from the theme panel and the content of the page will display here. You can even use the drag and drop builder to create this! This is a perfect place for your company mission statement, alerts, notices or anything else.

Get In Touch

Email: support@total.com
Phone: 1-800-Total-Theme
Address: Las Vegas, Nevada

Our Location

info@3dprinter.info

Birch Wood

£31.50

Rated 0 out of 5
(be the first to review)

Only 2 left in stock

Category: Tags: , ,

Description

EasyWood is a wood-filled PLA-based filament which is gravimetrically filled with approximately 40% grinded wood particles. EasyWood is a very easy to print wood filament as it is based on our EasyFil PLA compound and the 40% gravimetrical filling with grinded wood particles make the filament absolutely warp-free.
EasyWood looks, feels and smells like real wood and beautiful wood-nerve structures can be obtained by grinding the printed object a bit with a piece of fine grit sandpaper or by varying with the printing temperature.

 

Unique features

  • Extremely high wood-filling of 40%
    • Real wood feel, look and smell
  • Very easy to print
    • Warp-free printing and no deformation after cooling
    • Great thermal stability and filament flowing behaviour
    • Perfect first- and inter-layer adhesion
    • Can be printed at high printing speeds
  • Create wood-nerve structures
    • By postprocessing the printed object with a piece of fine grit sandpaper
    • By varying with the print/extrusion temperature
  • Biodegradable

General printing guidelines *

Nozzle size: ≥ 0.4mm Layer height: ≥ 0.2mm Flow rate: ± 104%
Print temp: ± 210 – 240° C Print speed: Low Retraction: Yes ± 5mm
Heat bed: ± 0 – 60° C Fan speed: 50-100% Experience level: Beginner

*) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.

Filament length

ρ: 1.20 g/cc 50 gr coil 0.5 Kg spool 2.3 Kg spool
Ø 1.75mm ± 17.3m ± 173m 797m
Ø 2.85mm ± 6.5m ± 65m 300m

Nozzle cleaning

When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.

Reviews

There are no reviews yet.

Leave a customer review

Your email address will not be published. Required fields are marked *

Back To Top